Moffat A311 Dokumentacja

Installation and Operation Manual Gas Target Top Range Electric Ovens Date Purchased Serial Number Dealer Service Provider 232456-10 RN8110GE RN811

8 Installation Gas Connection NOTE: ALL GAS FITTING MUST ONLY BE CARRIED OUT BY AN AUTHORISED PERSON. 1. It is essential that gas supply is correct

9 Installation NOTE: Measure burner operating pressure at manifold test point with target top burner (Inner and outer ring) operating at full setting

10 Installation NOTE:  This appliance must be earthed.  Fixed wiring installations must incorporate an all-pole disconnection switch. 9. Correct

11 Operation Operation Guide 1. Waldorf appliances have been designed to provide simplicity of operation and 100% safety protection. 2. Improper ope

12 Operation Lighting Pilot Burner (Target Top) 1. Remove centre casting with casting removal tool. 2. Depress control knob and rotate anti-clockwis

13 Operation Oven The oven is fitted with top and bottom elements. The thermostat maintains overall oven temperature. Top element is further control

14 Cleaning and Maintenance General Clean Target Top / Range regularly. A clean appliance looks better, will last longer and will perform better. Ca

15 Cleaning and Maintenance Target Top a. This should be kept clean of any build up of spillage’s of food. Provided the cast iron work surface is r

16 Fault Finding This section provides an easy reference guide to the more common problems that may occur during operation of your appliance. The fau

17 Wiring Schematic RN(L)8110GE

The reproduction or copying of any part of this manual by any means whatsoever is strictly forbidden unless authorized previously in writing by the ma

18 Wiring Schematic RN(L)8110GEC

19 Wiring Schematic Wiring Layout for Static Oven Wiring Layout for Convection Oven

20 Gas Conversion and Specifications Conversion Procedure NOTE:  These conversions should only be carried out by qualified persons. All connections

21 Gas Conversion and Specifications NOTE: Ensure pilot burner and thermocouple are correctly located and pilot burner aligns with main burner igniti

22 Gas Conversion and Specifications Gas Type Identification Label On completion of the gas conversion, replace gas type identification label, located

23 Replacement Parts List Replacement Parts List When ordering replacement parts, please quote part number and description as listed below. If part r

24 Replacement Parts List General 227012 Centre Casting. 227013 Half Plate Casting. 014997 Casting Removal Tool. 227892 Side Rack LH. 227893 Side R

Contents Waldorf Gas Target Top Range Electric Oven RN(L)8110GE Gas Target Top Range Electric Static Oven. RN(L)8110GEC Gas Target Top Range Elec

2 Introduction We are confident that you will be delighted with your WALDORF Gas Target Top Range Electric Ovens and it will become a most valued appl

3 Specifications Model Numbers Covered in this Specification RN[1]8110GE Gas Target Top Range Electric Static Oven - 900mm. RN[1]8110GEC Gas Tar

4 Specifications Electrical Supply Requirements Electrical Connection Electrical supply connection point is located at rear of appliance, approximate

5 Dimensions Dimensions RN(L)8110GE / GEC

6 Installation Installation Requirements NOTE:  It is most important that this appliance is installed correctly and that operation is correct before

7 Installation Clearances NOTE: Only non-combustible materials can be used in close proximity to this appliance. * Side clearances can be 50mm when a